 | Product: MEGA BAR 50RGB RC | The ADJ Mega Bar 50RGB RC is a compact 22-inch (1/2-meter) LED lighting Bar that offers the power of RGB color mixing for stage or wall washing. The Mega Bar 50RGB RC features an Infrared wireless remote to control what would normally require a DMX controller or adjustments made by hand on the rear panel. Aim the wireless remote at the unit and control features such as: Black Out, built-in programs, flash, DMX addressing and RGB color change.
This fixture uses LEDs rated at 100,000 hours with a maximum power draw of 30W. DMX addressing may also be changed by the units 4-button LED display. There is no duty cycle on the Mega Bar 50RGB RC, plus users can daisy-chain the power from one unit to the next with the built-in IEC power Ins/Outs.
Features & Specifications:
1.5 foot/.5 meter ultra bright, indoor LED Color Bar with 125, 10mm LEDs (24 Red, 54 Green, & 47 Blue LEDs)
Includes wireless infrared remote control up to 30 ft./10M (Model: ADJ LED RC)
7 DMX Channel modes: 1, 2, 3, 4, 5, 6 & 7 channel modes
7 Operational modes: Manual Color Mode; Color Change Mode; Color Fade Mode; Auto (Program Run) Mode; Sound Active Mode; RGB Manual Control Mode and DMX-512 Mode
Great as an architectural wall wash or for performance stages where traditional stage lighting emit a lot of heat onto performers
Smooth RGB color mixing (fast or slow color change operation)
32 built-in Color Macros
Color strobe effect
DMX-512 Protocol
Electronic Dimming: 0 - 100%
Beam angle: 40-degree
Linkable via 3-pin XLR cable
4-button LED display on rear panel
IEC AC outlet on rear to daisy chain power
Includes mounting brackets
Long life LED (Rated at 50,000 hrs.)
Low power consumption
Very low heat output
Run all night No duty cycle
Multi-voltage: 90-240V, 50/60Hz
Power Draw: 18W max
Dimensions (LxWxH): 22 x 2.5 x 4 / 560x63x102mm
Weight: 3 lbs. / 1.5 kg.
ADJ LED RC Infrared Remote Control Features:
Black Out: Turns fixture On/Off
Auto Run: Automatically run through built-in programs
Program Selection: Access units built-in programs
Flash: Strobe effect
Speed: Control speed of Auto Run
Sound Active: Activates sound active mode
Slave: Designates the fixture as a slave fixture in the Master/Slave configuration
Set Address: Set DMX Address on a fixture
RGB Buttons: Adjust RGB colors with the + and - buttons
+ and Buttons: Adjust flash rate, speed of the Auto Run and Program Selection |
| |
|
|
