The ADJ PRO38B RC is high output black Par Can with twelve 1-Watt LEDs that is ideal for lighting up stages, dance floors and entertainment venues. The fixtures RGB color mixing allows users to get a full spectrum of color from one Par Can. The PRO38B RC features an Infrared wireless remote to control what would normally require a DMX controller or adjustments made by hand on the rear panel. Aim the wireless remote at the unit and control features such as: Black Out, built-in programs, flash, DMX addressing and RGB color change.
This fixture uses LEDs rated at 50,000 hours with a maximum power draw of 15W. DMX addressing may also be changed by the units 3-button LED display. The PRO38B RC has a dual hanging bracket that makes it easy to set on the floor.
Specifications:
Black Ultra bright Par 38 with 12x 1-Watt LEDs (4 Red, 4 Green, & 4 Blue LEDs)
Great for performance stages where traditional par cans emit a lot of heat onto performers
Includes wireless infrared remote control up to 15 ft./4.5M (Model: ADJ LED RC)
7 DMX Channel modes: 1, 2, 3, 4, 5, 6 or 7 channel modes
6 Operational modes: Manual Color Mode; Color Change Mode; Color Fade Mode; Auto (Program Run) Mode; Sound Active Mode and DMX-512 Mode
Smooth RGB color mixing (fast or slow color change operation)
Flicker-free operation for film and television
32 built-in Color Macros
Color strobe effect
Electronic Dimming: 0 - 100%
Beam angle: 30-degree
Linkable via 3-pin XLR cable (In/Out)
3-button LED display on rear panel
Dual bracket system allows fixture to be hung or set on the ground
Power Draw: 15W max
ETL & ETLC Approved
Run all night No duty cycle
Long Life LEDs (50,000 hrs.)
Multi-voltage: 120-240V, 50/60Hz
Dimensions (LxWxH): 7.25 x 7.25 x 9.5/ 185x185x240mm
Weight: 4 lbs. /1.5 kgs.
Specifications subject to change without notice.
ADJ LED RC Infrared Remote Control Features:
Black Out: Turns fixture On/Off
Auto Run: Automatically run through built-in programs
Program Selection: Access units built-in programs
Flash: Strobe effect
Speed: Control speed of Auto Run
DMX Mode Select
Sound Active: Activates sound active mode
Slave: Designates the fixture as a slave fixture in the Master/Slave configuration
Set Address: Set DMX Address on a fixture
RGB Buttons: Adjust RGB colors with the + and - buttons
+ and Buttons: Adjust flash rate, speed of the Auto Run and Program Selection
|
|
