Skip Navigation Website Accessibility

Dynacord DSP 2 x 650 w power amplifier for fixed install applications C1300FDi

DSP 2 x 650 w power amplifier for fixed install applications

  • Professional DSP amplifier for live and mobile application
  • Fully integrated professional speaker processing with FIR drive technology
  • Market-leading acoustic performance and rock solid reliability
  • Intuitive, simplified set-up, control and operation in SONICUE sound system software with firmware 2.0

Dynacord C Series amplifiers are dedicated installation DSP amplifiers optimized for 24/7 operation. Integrated digital signal procesing provides access to professional speaker processing with FIR Drive technology. C Series amplifier utilize Class A/B resp. Class H topologies, which provide market leading acoustic performance and reliability. The connectivity is optimized for the needs of fixed install applications. For low cost of ownership a power saving standby mode is available. A front panel LC display allows local control and supervision of the amplifier. An intuitive system control software allows fast system setup, flexible system control and comprehensive supervision.

Load Impedance
2 Ω, 2.6Ω, 4 Ω, 8 Ω

Maximum Output Power, Single Channel
1100 W, 950 W, 660 W, 350 W

Maximum Output Power, Dual Channel
1000 W, 850 W, 600 W, 320 W

Maximum Output Power, Bridged
2000 W, 1200 W

Direct Drive
70 V Operation, 100 V Operation

Load Capability
not avaliable

Dual Channel Bridged
1 x 625 W (0.0 dB)

Maximum RMS Voltage Swing THD = 1%, 1 kHz
55.3 V

Voltage Gain Ref.1 kHz
32.0 dB

THD at 450 W/4Ω MBW = 80 kHz, 1kHz
< 0.05%

IMD-SMPTE, 60 Hz, 7 kHz
< 0.1%

DIM30, 3.15 kHz, 15 kHz
< 0.05%

Maximum Input Level
+21 dBu

Crosstalk ref. 1 kHz, at 100W/4 Ω
< -80 dB

Frequency Response, ref. 1 kHz
10 Hz to 21 kHz (±1 dB)

Input Impedance, Active Balanced
20 k Ω

Signal to Noise Ratio Amplifier, A-weighted, ref to Max. Output Power@ 8  Ω
>104 dB

Output Noise, A-weighted
< -68 dBu

Output Stage Topology
Class AB

Power Requirements
240 V, 230 V, 120 V or 100 V; 50 Hz to 60 Hz (factory configured)

Power Consumption ? Maximum Output Power @ 4 Ω
550 W

Mains Fuse
240 V/230 V: T10AH; 120 V/100 V: T20AH

Audio limiters, high temperature, DC, HF, Back-EMF, Peak current limiters, Inrush current limiters, Turn on delay

Front-to-rear, 3-stage-fans

Ambient Temperature Limits
+5°C to +40°C (40°F to +105°F)

Safety Class


Dimensions (W x H x D), mm
483 x 88 x 462.4

12.9 kg (28.4 lb)

Remote Power ON/GPIO
Power remote via switch, delay time selectable Floating relay contacts (show protect mode) Inputs for preset selection

Signal Processing
FIR filters, audio limiters, output and array** delay, 10-band** user PEQ, 5-band array PEQ** per channel, load impedance

Remote Control
SONICUE sound system software (requires firmware 2.0)

RMK15 (rear rack mount kit)